After two years of intensive R&D, it was time to boost the Gyeon coating spectrum to a new level: presenting a technological rEVOlution in the chemical group of polysilazanes, Gyeon has succeeded both in almost doubling the durability and simplifying the application process: wipe off time has been drastically extended with the new EVO formulations.
What's more: all new EVO coatings no longer require a two-layer application but only one single layer, and what's more, they can even be applied outdoors in the fresh air; a garage is no longer a mandatory requirement. The only thing to ensure is a dry place for the following 12 hours and some shade for the application.
Q² One EVO is the entry-level silica-based coating from Gyeon. It is ideally suited for price-conscious users who are looking for maximum performance with the most efficient use of resources.
Similar to its bigger brother Q² Pure EVO, Q² One EVO creates an impressive candy effect and is a modern counterpart to high-quality natural waxes in terms of durability. The fantastic depth of colour is accompanied by a durable and highly chemical resistant protection against all kinds of environmental influences, which guarantees a quick and easy cleaning of your vehicle.
- Durability: up to 24 months or 25 tkm
- Consumption: 30 ml / vehicle
- 1 piece GYEON Q² One EVO 30 / 50 / 100 ml
- 1 piece GYEON Q²M Cure 100 ml (not included in the Light Box)
- 1 piece GYEON Q²M Coating Applicator
- 1 piece GYEON User Manual
The better the surface is prepared, the better the result in terms of gloss, durability, and water repellency.
- Thorough pre-wash and decontamination with Q²M Foam, Q²M Tar, Q²M Iron, Q²M Clay
- Polish all painted surfaces to a high gloss with Q²M Polish and optionally Q² Primer
- Wash vehicle with highly degreasing detergent, e.g., dishwashing liquid and hot water
- Remove all contaminants, waxes, and oil-based polish residues with Q²M Prep (IPA alone is not sufficient)
- Shake the bottle, apply a few drops of Q² One EVO on the applicator
- Apply in a cross-motion until the layer is uniform and saturated, working on smaller sections at a time
- After 10-30 seconds, polish off excess with a fresh microfiber cloth Q²M BaldWipe to achieve an even finish
- After 1 hour, apply Q²M Cure Spray as a topping and wipe with Q²M SoftWipe to protect against potential water spots
- Avoid water during the drying time (24 hours); do not wash with car shampoo during the curing phase (14 days)
Be the first to rate! Your review helps us and others!
Your opinion is very important to us! We want to make sure that you are fully satisfied with our car care products. Let us know what you think after you have tested the product and share your experience with our community. Be the first to review this product and help others make the right decision. We are looking forward to your feedback!