Allow me to introduce myself: Q² One is an affordable basic coating for beginners who are tackling the subject of ceramic sealants for the first time but require more performance than with the GYEON Q² CanCoat, for example.
The fundamental characteristic of Q² One is its fascinating ease of application. This highly developed silicon-based product (SiO2) can be used even by inexperienced beginners and is comparable to the application of natural waxes. Appropriate paint preparation, as is also necessary with waxes, consists of defect correction and surface degreasing, e.g. with Q²M Prep. An ergonomic applicator, which is part of the set, allows you to apply the product quickly and effectively to the paint; buffing out is even easier than with a conventional wax.
Q² One is resistant to chemicals with a pH value between 2 and 11, guaranteeing easy cleaning regardless of the chosen car wash method. It is even resistant to aggressive chemicals like from a car wash.
If you decide to protect your car with Q² One, you will gain a lasting protection of up to 12 months or 20,000km against oxidation on the paintwork, burns caused by bird droppings, road chemicals or salt, combined with the impressive visual beading effect.
-Durability: up to 12 months or 20tkm.
-thickness: 0.2-0.5µ
-pH tolerance: pH 2-11
-contact angle: >110
-hardness: +2H
-Consumption: 30 ml/vehicle
-Single-stage coating, layering possible
Bukit Batik Crescent 1
Singapor, Singapur, 658064
-1 piece GYEON Q² One 50 ml
-1 piece GYEON instructions for use
The better the surface is prepared, the better the result in terms of gloss, durability and beading effect.
-Thorough pre-wash and decontamination with Q²M Foam, Q²M Tar, Q²M Iron, Q²M Clay.
-Polish all painted surfaces to a high gloss with Q²M Polish and, if necessary, Q² Primer.
-Wash the vehicle with a strongly degreasing detergent, e.g. dishwashing liquid and hot water.
-Remove all dirt, waxes and oily polish residues with Q²M Prep (IPA alone is not enough).
-Shake bottle, put a few drops of Q² One on the suede cloth wrapped around the applicator.
-Apply in a criss-cross pattern until the layer is thick and even, working on smaller sections at a time.
-After 10-30 seconds, buff out any excess with a fresh Q²M BaldWipe microfibre cloth to achieve an even finish.
-After 1 hour, apply Q²M Cure Spray as a topping and wipe off with Q²M SoftWipe to protect against possible water spots.
-Avoid water during the drying time (24 hours), do not wash with car shampoo during the curing phase (14 days).
Be the first to rate! Your review helps us and others!
Your opinion is very important to us! We want to make sure that you are fully satisfied with our car care products. Let us know what you think after you have tested the product and share your experience with our community. Be the first to review this product and help others make the right decision. We are looking forward to your feedback!