SONAX PROFILINE CeramicCoating CC Plastic + Rubber is a ceramic sealant based on Si-Carbon technology for refreshing and protecting unpainted exterior plastic parts such as trims and bumpers.
The extremely flexible coating is also suitable as tire coating and protects against fading caused by UV radiation. It gives the surfaces strong water and dirt-repellent properties and is very easy to apply.
Set with 4 application pads.
- Content: 50 ml
- 1 piece SONAX PROFILINE CeramicCoating CC Plastic+Rubber 50 ml
- 4 pieces SONAX Applicator
- Wash and degrease the surface
- Dispense a few drops of CC Plastic+Rubber onto the soft foam side of an applicator pad
- Apply in thin, small sections to the surface
- Ideally, mask contact points to the bodywork beforehand to prevent any product from reaching the paint
- If it does happen, immediately wipe with the microfiber cloth used for preparation
- After a short dwell time of approximately 3-5 minutes, wipe off excess product with a new soft-touch microfiber cloth
- Then, the coating should cure for at least 6 hours
- Throughout this time, the vehicle must be in a dry environment, and the surfaces should not be touched anymore
- We recommend allowing the coating to rest for 12 hours for optimal product efficacy to ensure a complete reaction with the surface
- Always use pH-neutral shampoos for washing
- Avoid using alkaline cleaners
Be the first to rate! Your review helps us and others!
Your opinion is very important to us! We want to make sure that you are fully satisfied with our car care products. Let us know what you think after you have tested the product and share your experience with our community. Be the first to review this product and help others make the right decision. We are looking forward to your feedback!